SECTION 501-12: Instrument Panel and Console
2014 Flex Workshop Manual
REMOVAL AND INSTALLATION
Procedure revision date: 05/02/2013

Compressor Driver Module

  1. Remove the rear floor console refrigerator. Refer to Refrigerator .

  1. NOTICE: Do not bend the condenser tubes. The screwdriver must fit between the condenser tubes or damage may occur to the refrigerator.

    Using a long thin screwdriver, remove the philips screw from the compressor driver module mounting bracket.
  1. Disconnect the upper electrical connector from the compressor driver module.
  1. Rotate the compressor driver module to the right and remove from the mounting bracket.
  1. Disconnect the lower electrical connector from the compressor driver module.
  1. Disconnect the compressor driver module-to-refrigerator electrical connector.
  1. To install, reverse the removal procedure.