Safety Belt Inflator — Second Row, 40 Percent

Removal

 WARNING: All safety belt components must be inspected and corrected as part of any collision repair. Inspect all safety belt components as prescribed by Safety Belt Inspection and Repair After a Collision found in Section 501-20A General Procedures of this manual. Failure to follow this instruction may result in incorrect operation of the safety belt system and increase the risk of serious personal injury or death in a crash.

 WARNING: Always carry or transport a live safety belt inflator with the safety belt buckle bolt installed in the inflator tube hand tight. Failure to follow this instruction may result in serious personal injury in the event of an accidental deployment.

 WARNING: Never disassemble or tamper with seat belt deployable components, including pretensioners, load limiters and inflators. Never back probe deployable device electrical connectors. Tampering or back probing may cause an accidental deployment and result in personal injury or death.

1. Depower the SRS . Refer to Section 501-20B .

2. Remove the safety belt buckle. Refer to Safety Belt Buckle — Second Row, 40 Percent, With Inflatable Safety Belts .

3. Remove the safety belt inflator bolt.

4. Lift the locking wedge and disconnect the safety belt inflator electrical connector.

5. Remove the safety belt inflator.

Installation

1. Connect the safety belt inflator electrical connector and push the locking wedge in.

2. Position the safety belt inflator and install the bolt.
   • Tighten to 3.5 Nm (31 lb-in).

3. Install the safety belt buckle. Refer to Safety Belt Buckle — Second Row, 40 Percent, With Inflatable Safety Belts .

4. Repower the SRS . Refer to Section 501-20B .