Radiator — 3.5L Ti-VCT

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Drain the cooling system. Refer to Cooling System Draining, Filling and Bleeding .

2. Remove the cooling fan motor and shroud. Refer to Cooling Fan Motor and Shroud — 3.5L Ti-VCT .

3. Remove the front bumper cover. Refer to Section 501-19 .

6. • To install, tighten to 6 Nm (53 lb-in).

8. NOTE: Make sure the radiator insulators are in place when installing the radiator.

Installation

1. To install, reverse the removal procedure.

2. Fill and bleed the cooling system. Refer to Cooling System Draining, Filling and Bleeding .