2014 Flex Workshop Manual

SECTION 413-13C: Active Park Assist	2014 Flex Workshop Manual
REMOVAL AND INSTALLATION	Procedure revision date: 05/02/2013

Active Park Assist Sensor

NOTE: LH side shown, RH side similar.

Item	Part Number	Description
1	—	Active park assist sensor electrical connector (part of 14290)
2	15K859	Active park assist sensors (2 required)

Removal and Installation

Remove the front lower air deflector. For additional information, refer to Bumper — Exploded View, Front in Section 501-19 .

Disconnect the electrical connector.

With a suitable tool (such as a flat-blade screwdriver), gently pry the retaining tabs to remove the active park assist sensor(s).
- Remove the active park assist sensor(s) from the front bumper cover.

To install, reverse the removal procedure.

After installing the sensor(s), use the scan tool to verify that the active park assist sensor PIDs responding correctly. Carry out the Azimuth System Check in this section. If the parking aid sensor does not respond correctly, refer to Active Park Assist in the Diagnosis and Testing portion of this section.